Roofing Melba homes the way we have since 2002 — measured on site, priced in writing, and finished the way we would want our own roof finished.
Pick a service to see how we handle it and what the job usually looks like on a Melba roof.
If two other people have caulked it and it still leaks, call us. Most stubborn leaks turn out to be flashing, a valley, or a fastener nobody thought to check.
Steam and hand work, never a hammer and chisel on your roof. Then we check the eaves for the damage the ice already did.
A careful walk over the whole roof — panels, shingles, valleys, flashing, fasteners — plus the attic side when there is a way in. You get photos and a straight answer.
Guards and screens so you are not up a ladder every fall digging pine needles out of the gutter by hand.
This is the work our name is attached to. Two decades of tin roofs on houses, churches, barns and additions, installed by crews who cut the trim on site instead of forcing something that almost fits.
The layer you never see is what keeps water out on the ugly days. We do not thin it out to save a few dollars on a bid.
Wind and debris damage is not always obvious from the ground. We check the edges, the ridge, the valleys and the fasteners before telling you anything is fine.
We still shingle plenty of roofs. Cracked, curled and blown off shingles get replaced, and the valleys and flashing get reworked while we are up there.
Old skylights leak at the flashing long before the glass ever fails. We reflash, reseal, or set a new unit and tie it in properly.
Careful footwork, matched materials, and flashing done the way it was done when the roof went on.
A replacement is a big spend and it should feel orderly. We schedule around dry weather, work in the right order, and never leave a house open overnight.
Where it makes sense we set low slope metal over a problem section so it finally drains instead of ponding after every rain.
Coatings for low slope and older metal roofs that are still sound but weathered. Washed down, refastened, primed at the rust, then coated.
Hard wind lifts shingles and works panel fasteners loose along the edges, which is exactly where the next storm gets underneath. We refasten, replace and reseal.
Churches, shops, barns and small commercial buildings. We have roofed everything from a wood shed to a steeple.
A limb through the roof or panels peeled back overnight needs covering now, not next week. We get it dried in first so the inside of the house stops taking damage.
A twenty year old panel roof usually needs fasteners and sealant, not replacement. We refasten with new washers and get you another long stretch out of it.
The edge of a roof is where most trouble starts. New fascia, new soffit, wrapped or painted so it stays sound.
Repair or replace, we handle both, and we work from what the roof actually needs rather than from what an adjuster might approve.
Most roofs somebody has called a lost cause are not one. We repair what can be repaired, and we tell you honestly when a repair will no longer hold.
Roofing Brothers began in 2002 as a family roofing company in Morganton, North Carolina, and it is still run the way it started. Homeowners in Melba reach that same outfit — the one that has been setting metal panels and laying shingles for over twenty years — through our network of local crews.
In a city the size of Melba, word travels fast about who does good work and who does not. That suits us fine. We would rather put one roof on right and have the neighbors ask about it than chase volume all over Idaho.
Nothing fancy — free estimates, honest answers, and roofs that go on straight.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
Somebody comes out, measures, gets on the roof, and leaves you a written price. No charge, no obligation, and no number that expires if you do not sign today.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
Beds get covered, tear off gets hauled as we go, and a magnet goes over the drive before we pull out. Your yard should look like we were never there.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
Common questions from Melba, ID homeowners about metal roofs, repairs and what a roof costs.
Much less than people expect. Over solid decking with underlayment under it, a Melba metal roof sounds about like a shingle roof from inside the house. The loud tin roof people remember was screwed straight to open purlins over a barn with nothing underneath.
No. Estimates are always free in Melba. We come out, measure, look in the attic if we can get to it, and leave you a written price. Nobody will push you to sign anything that day, and the number does not expire in an hour.
A typical Melba shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
Any dry stretch works. We roof in Melba year round, though we schedule shingle work for when it is warm enough for the strips to seal properly, and we watch the forecast so your house is never left open overnight.
Often, yes. Plenty of the Melba roofs we get called to look at need flashing reworked or a section refastened, not a whole new roof. We will tell you honestly which one you are looking at, and if it is repairable we would rather repair it.
Most Melba houses are a two to four day job. A straightforward shingle roof can be done in a day or two. A cut up metal roof takes longer because every panel, valley and trim piece is measured and fit on site rather than pulled out of a box.
What people say once the crew has packed up and gone home.
"Cannot say enough about how careful they were around the flower beds. Everything got covered and nothing was trampled."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Very pleased with the roof. The only thing I would mention is that the estimate took a couple of days to come back, but once it did everything went right on schedule."
Looking for a roofer just outside Melba? These areas are covered too.